Sputter coater
From Applied Optics Wiki
Revision as of 11:29, 5 May 2010 by Matt (talk | contribs) (Created page with 'To callibrate the sputterer FTM coat to a nominal thickness then pass the sample to Rod Dykeman who'll scratch the coating and measure it using a Tallystep. If the coating i…')
To callibrate the sputterer FTM coat to a nominal thickness then pass the sample to Rod Dykeman who'll scratch the coating and measure it using a Tallystep.
If the coating is too hard (eg ITO) then you'll have to mask out some areas using photoresist and lift off to provide an edge. This might be possible using some dabs of photoresist rather than a spincoated layer and mask exposure.
